All-Polyimide (KAPTON®) Heaters
Minco Products, Inc
Minco's all-polyimide heaters offer a high-performance alternative to standard polyimide flexible heaters, supporting higher temperatures and greater watt densities for demanding applications.
Typed specifications19 values
Discloses 3 of 7 fields engineers filter by in this category (category median 2).
- Mass
- 0.04 g typ. · datasheet p.6
- Envelope (L×W×H)
- 560 mm × 1145 mm datasheet p.10
- Operating temperature
- -200–260 °C datasheet p.10 -200–260 °C All-Polyimide (AP), -328 to 500 °F
- Product type
- heater All-Polyimide (AP) heater · datasheet p.11
- Material
- polyimide film with polyimide adhesive datasheet p.11
- Connector
- welded leadwires (standard), solder pads, insulation displacement connectors, pin headers, SMT and ZIF termination, flex circuits datasheet p.8
- Max available size (L × W)
- 560 mm x 1145 mm (22" x 45") datasheet p.11
- Min available size (L × W)
- 6.4 mm x 6.4 mm (0.25" x 0.25") datasheet p.7
- Max resistance density
- 230 Ω/cm² max · datasheet p.10
- Heater construction
- etched foil etched-foil resistive heating element laminated between layer… · datasheet p.7 polyimide (Kapton) film polyimide film with polyimide adhesive
- Redundancy
- dual redundant circuits dual element for redundancy and/or warm-up and maintenance he… · datasheet p.8 single circuit single or dual element
- Outgassing
- other excellent chemical resistance and low outgassing of AP heaters · datasheet p.9
- Temperature sensor
- PT100 RTD datasheet p.10 bimetallic (mechanical thermostat) thermostat, snap action or creep action, specify setpoint | thermocouple type E, J, K or T laminated inside heater
- Mounting
- adhesive bonded factory bonded AP heaters eliminate clamping and provide opti… · datasheet p.9
Each value is typed with its unit and measurement condition and cites the datasheet page it was taken from. Nothing is guessed: a field that is absent here has not been published by the manufacturer. machine-extracted ✓ checked by NewSpace Market ✓ manufacturer confirmed by the manufacturer.
As published by the supplier4 lines, in the manufacturer's own wording
- Maximum operating temperature
- 260°C
- Max. size
- 560 mm x 1145 mm
- Max. resistance density
- 230 Ω/cm² (1500 Ω/in²)
- Temperature range
- -200 to 200 °C
About
Offering a high-performance alternative to standard polyimide flexible heaters, all-polyimide heaters support higher temperatures and greater watt densities than most flexible film heaters available on the market. Minco’s unique ability to manufacture these heaters has prompted success in many high-temperature applications worldwide. These thin, lightweight heaters allow you to apply heat where it is needed, ultimately reducing overall operating costs. They provide fast and efficient thermal transfer, and their low mass construction and factory lamination save space and reduce cycle time. Available in round, rectangular, and irregular shapes, these heaters are also resistant to most chemicals. Customization options enable turnkey assembly, and they boast a maximum operating temperature of 260°C.
Documentation
- Minco-Thermal-Solutions-Design-Guide.pdf PDF source: www.minco.com ↗
- MIN1017_Integrating-Thin-Film-Sensors-Into-Polyimide-Heaters_v1a.pdf PDF source: www.minco.com ↗
Need the full ICD, test reports or a specific revision? Ask the supplier directly.